Contents
-Communication channel: ISM, 433MHZ
-Power: 2* AA alkaline batteries
-Wireless transmission range: 40 meters without obstacle
-Encoder: 100PPR
-Button: 13
-Transmit power: 10DB
-Acceptance sensitivity: -98DB
-Maximum axis: 4/6 axis
-Display screen: dot matrix LCD backlight display screen
-Material: PC and ABS material, good resistance to heat and toughness, and a silicone sleeve protection
WHB04B-4 4 axes, support 4 axes with x,y,z, a
WHB04B-6 6 axes, support 6 axes with x,y,z,a,b,c
Features
- Radiofrequency: 433MHz, ISM, the Tx power is 10DB and the RX sensitivity is -98DB
- The RF has 64 channels, the channel gap is 1 Mhz
- Using frequency hopping, stable and reliable
- Hopping transmission technology can support 64 sets of equipment, each other is not affected
- 100PPR manual pulse generator, support 10 macro function button
- LCD Display: machine coordinates and workpiece coordinates
- X, Y,乙 A, Bz C-axis
- LCD Display: Spindle speed value, processing feed rate value
Application
For Windows: MACH3 System
Parameter
– Communication channel: ISM, 433MHZ
– Power: 2* AA alkaline batteries
– Wireless transmission range: 40 meters without obstacle
– Encoder: 100PPR
– Button: 13
– Transmit power: 10DB
– Acceptance sensitivity: -98DB
– Maximum axis: 4/6 axis
– Display screen: dot matrix LCD backlight display screen
– Material: PC and ABS material, good resistance to heat and toughness, and a silicone sleeve protection
LCD display
Display the machine coordinate and workpiece coordinate of the X Y Z A axis.
Display spindle speed value, machining feed speed value.
Dot-matrix LCD with backlight
Axis selection, rate band switch control
The axis selection band switch realizes the closing of the electronic handwheel and the selection control of the corresponding X Y Z A-axis functions.
The selection of the band switch realizes the selection of the step value, which is simple and convenient.
General Characteristics
| MPG Encoder | 100PPR |
| USB cable | 5m |
| Function Key | 18 Keys |
| Maximum axis | 6 axis |
| LCD | 128*68 Dot LCD with background |
| Material | ABS、PC、aluminium |
XHC WHB04 Driever Download
Manual
How to pair and use WHB04 Wireless Handwheel and USB receiver
Open the pairing software XHC-PHBX-内部测试-V1.2
As shown below, the software will prompt please insert USB reviver.
After inserting the receiver, if it prompts “PHBX job ok!”, it means that the receiver is successfully recognized by the computer. If there is no prompt, it means that the receiver is not recognized, please check.
After the receiver is correct, click the re-pairing button on the software, then turn on the power with the handwheel, press and hold the RESET button for 5 seconds, and then release it.
