NVEM CNC Controller Ethernet

novusun nvem v2

Can control up to 3/4/5/6 stepper motor at the same time.
Support Motor: Servo motor, Stepper motor. 
With 12 channel programmable input port.  
With 10 channel programmable output port. 
1 channel standard MPG interface PWM output control
Ethernet interface, support MACH3 software
DC electrical isolation Optocoupler isolation  
Up to 200KHz stepper motor control pulse output

Price AT ALiExpress

Applications

12 ports photoelectric isolated input interface for ordinary digital data;
10 ports photoelectric isolated output interface for ordinary digital data;
1 port 0-10V spindle speed analog output interface (can change to PWM output); 
Support 3-6 axis stepper systems, 200 KHz pulse output for every axis; 
ARM motion control chip;

Novusun NVEM V2 Driver and Manual

19 thoughts to “NVEM CNC Controller Ethernet”

  1. Hello, I would like to ask if it is possible to obtain information about the D1 diode on the PCB. Unfortunately, my driver does not have this diode (you can clearly see a cold solder) and probably because of this there is no power supply.

    1. INDEX signal is a INPUT PIN that reads the RPM from spindle or motor. This is specially important at lathes that you want to make a THREAD. But by the way, this INDEX signal still does not work (yet).

  2. I only enjoyed the device for less than 6 hours . For the brief time I used the NVEM V2 I found it to be more reliable than the NVUM V2 as far as connection stabiliity and reliabilty goes. But as I attempted to install the UART file plugin I ended up triggering a firmware update finding myself having to ask you for the binary of the V2 and any software for updating correctly my 6-axis NVEM V2. I certainly would appreciate the binary becominig available on the site. Failing that an e-mail with it would be great!

  3. Hello, I tested the controller before building my CNC, after a few month now I got everything setup, first all axis and spindle are working fine. But out of a sudden the controller demand a *.bin file. Try setup another PC but without any luck. It seems like the controller lost it’s firmware (stating update can’t succeed without the *.bin file)

    Can you supply the bin file and what to do about that?

  4. NVEM V2 plugin from this site, messes up the option to Motor tuning in Mach3. Graph cant be regulated.
    There is no support, just an awful experience.
    If your thinking to buy ANITHING from Novusun do more research.

  5. Hello i have a NVEM V2 6 axis controller but the B and C axis will not work
    i am useing mach 3 and when i click on plugins it says it is a four axis
    Please can anyone tell me Y

    Thank you

  6. tenho 2 controladoras sem conexão com usb sinceramente nunca mais compro esta porcaria não tem nenhuma atualização na net falta de honestidade com compradores realmente pirata…

  7. Hello have the problem that the HF Sindel runs up extremely slow.
    The PWM 0-10V needs about 12 seconds to rise from 0 to 10V.
    How can I adjust this.

  8. Hello have the problem that the voltage 0-10V builds up very slowly and thus of course the RF spindle takes extremely long to Max. Speed comes. With me about 10-13 seconds.
    Can you set this somewhere?
    In Mach3 I find unfortunately nothing to adjust this.
    Can you help me further.

  9. Hello, I need to reach the 6 axis on the screen and their controller however only 4 of them displayed. Do you support screen set for 6 axis. Could you help me about it?

Leave a Reply

Your email address will not be published. Required fields are marked *